<:@gw1> where gw1=sipgate.de, does not work; delay on

hello everybody,

currently i have two problems with SPA3K:

problem#1.

configured Gateway1 (sipgate.de) does not work for outgoing calls (busy tones come up immediately when the match occurs), my configuration:

Line1:
---
Gateway1: sipgate.de
NAT mapping: yes
AuthID: 1234567
Password: PaSsWoRd
---
Dialplan: ([2-9]xxxx.<gw0>|0[2-9]xxxxx.<:gw0>||0049[2-9]xxxx.<:gw0>|01[4-7]xxxxxx.<gw0>|004918!|004919!|00xx.<gw1>)

so the last part 00xx.<gw1> says to dial all international calls thru Gateway1 where sipgate.de is the VoIP provider configured (i can not set it up as VoIP provider for Line1 because i have US number from Stanaphone.com on it already).

so if try to dial 0033xx. then surely call should be routed thru gw1 but as result i have busy tone meaning "service not available". maybe sipgate.de does not allow do outband calls without "normal" registration at all? :?

problem#2:

when i dial smth like 089xx. then surely i have to hop on gw0 (PSTN) as stands in dialplan to Line1. but immediately after dialing i hear ringing beeps BUT spa3k did not dial yet! so after ~10sec and these beeps spa3k goes off-hook and dials the number, then i see the real ringing beeps of callee. my "dialing pause" stands for 1 sec.

thank you!

anybody there? :beerdigu: