Hallo,
ich hab hier eine Beronet 4-Port Karte (BN4SO) an einem Anlagenanschluß. Wenn ich von außen anrufe bekomme ich (wenn in der misdn.conf debug=1 gesetzt ist) folgende Fehlermeldung:
P[ 1] I IND :SETUP oad: dad:4009910 pid:11 state:none
P[ 1] EXPORT_PID: pid:11
P[ 1] I SEND:RELEASE oad: dad:4009910 pid:11
P[ 1] --> bc_state:BCHAN_CLEANED
P[ 1] I IND :RELEASE_COMPLETE oad: dad: pid:11 state:EXTCANTMATCH
P[ 1] hangup_chan
P[ 1] -> hangup
P[ 1] * IND : HANGUP pid:11 ctx:Extern1 dad:4009910 oadnull) State:EXTCANTMATCH
P[ 1] --> cause:-1
P[ 1] --> out_cause:-1
P[ 1] --> state:EXTCANTMATCH
P[ 1] Channel: mISDN/1-1 hanguped new state:CLEANING
P[ 1] release_chan: bc with l3id: 2000a
der Ruf kommt also an aber "matcht" scheinbar nicht so daß sofort wieder aufgelegt wird. Hat jemand eine Idee was das sein könnte?
Joe
ich hab hier eine Beronet 4-Port Karte (BN4SO) an einem Anlagenanschluß. Wenn ich von außen anrufe bekomme ich (wenn in der misdn.conf debug=1 gesetzt ist) folgende Fehlermeldung:
P[ 1] I IND :SETUP oad: dad:4009910 pid:11 state:none
P[ 1] EXPORT_PID: pid:11
P[ 1] I SEND:RELEASE oad: dad:4009910 pid:11
P[ 1] --> bc_state:BCHAN_CLEANED
P[ 1] I IND :RELEASE_COMPLETE oad: dad: pid:11 state:EXTCANTMATCH
P[ 1] hangup_chan
P[ 1] -> hangup
P[ 1] * IND : HANGUP pid:11 ctx:Extern1 dad:4009910 oadnull) State:EXTCANTMATCH
P[ 1] --> cause:-1
P[ 1] --> out_cause:-1
P[ 1] --> state:EXTCANTMATCH
P[ 1] Channel: mISDN/1-1 hanguped new state:CLEANING
P[ 1] release_chan: bc with l3id: 2000a
der Ruf kommt also an aber "matcht" scheinbar nicht so daß sofort wieder aufgelegt wird. Hat jemand eine Idee was das sein könnte?
Joe