- Mitglied seit
- 21 Jul 2008
- Beiträge
- 3
- Punkte für Reaktionen
- 0
- Punkte
- 0
Hi all, I'm sorry for posting in English but my German writing is not good enough. My German-reading skills are a bit better but I could not find a solution for my problem:
I am using a FRITZ!Box Fon WLAN 7140 Annex A, Firmware version 39.04.56 with an external harddrive connected to the USB port (WD Mybook 250GB). Before installing Freetz 1.0, my WD MyBook was working fine on my Fritz!Box.
I wanted to use the SMB and NTFS features of Freetz, so I followed a guide and compiled a Freetz-enabled firmware (7140_04.56-freetz-1.0.en_20080719-153022.image) with StinkyLinux.
Installing this firmware went fine, all my Fritz!Box settings were kept and my Fritz!Box works fine for LAN, WLAN and VOIP. However, my WD MyBook is not detected anymore. When I go to USB Deviced on the FB webinterface I get:
No mass storage device is connected to FRITZ!Box.
I have tried different file systems (FAT32, NTFS, EXT2) and 2 different USB drives + a USB-stick. None of them showed up. When I connected my USB-printer, it was recognized just fine.
Can anyone help me solve this? What options should I check when creating the Freetz-image (in 'make menuconfig')?
I am using a FRITZ!Box Fon WLAN 7140 Annex A, Firmware version 39.04.56 with an external harddrive connected to the USB port (WD Mybook 250GB). Before installing Freetz 1.0, my WD MyBook was working fine on my Fritz!Box.
I wanted to use the SMB and NTFS features of Freetz, so I followed a guide and compiled a Freetz-enabled firmware (7140_04.56-freetz-1.0.en_20080719-153022.image) with StinkyLinux.
Installing this firmware went fine, all my Fritz!Box settings were kept and my Fritz!Box works fine for LAN, WLAN and VOIP. However, my WD MyBook is not detected anymore. When I go to USB Deviced on the FB webinterface I get:
No mass storage device is connected to FRITZ!Box.
I have tried different file systems (FAT32, NTFS, EXT2) and 2 different USB drives + a USB-stick. None of them showed up. When I connected my USB-printer, it was recognized just fine.
Can anyone help me solve this? What options should I check when creating the Freetz-image (in 'make menuconfig')?