Hallo,
zu meiner Konfiguration:
Anlagenanschluss <-> Patton 4638 FW 5.5 <-> 3cx
Funktioniert alles super. Nur habe ich das Problem, dass ankommende Anrufer, die ihre Rufnummer unterdrücken abgewiesen werden. "Der angerufene Teilnehmer ist z.Z.t nicht zu erreichen". Kennt jmd. dieses Phänomen?
GREETZ
Hallo!
Was hast du in der Route Rtg. 3Cx stehen?
default? .T?
Sonst ev. einen Debug bzw. die Konfig posten?
jwmdebug ccisdn signaling
debug call-control detail 5
debug call-router detail 5
debug context sip-gateway transport detail 5
debug context sip-gateway error detail 5
debug context sip-gateway signaling detail 5
Provider:
SIP-Provider:
PBX: asterisk
Phone(s): X-lite
Hallo,
hier meine Patton 4638 Config. Ich blick da leider nicht durch. Die hat mir die 3cx zusammen gebaut.......kannst du dir das mal bitte anschauen. Wenn ich später zeit habe, mach ich nochma die Debugs (falls benötigt)
DANKE!
Code:######################################################### # # For Patton SmartNode 4638/5BIS/UI 4-port BRI # Supported firmware versions R5.x # # Author: Kevin Attard Compagno # Contact: kevin@3cx.com # ######################################################### webserver port 80 language en system ic voice 0 profile ppp default profile call-progress-tone defaultDialtone flush-play-list play 1 1000 425 0 profile call-progress-tone defaultAlertingtone flush-play-list play 1 1000 425 -7 pause 2 4000 profile call-progress-tone defaultBusytone flush-play-list play 1 480 425 -7 pause 2 480 profile call-progress-tone defaultReleasetone flush-play-list play 1 240 425 -7 pause 2 240 profile call-progress-tone defaultCongestiontone flush-play-list play 1 240 425 -7 pause 2 240 profile tone-set default profile voip default codec 1 g711alaw64k rx-length 20 tx-length 20 codec 2 g711ulaw64k rx-length 20 tx-length 20 fax transmission relay t38-udp profile pstn default profile sip default profile aaa default method 1 local method 2 none context ip router interface IF_IP_WAN ipaddress dhcp tcp adjust-mss rx mtu tcp adjust-mss tx mtu interface IF_IP_LAN ipaddress 192.168.110.35 255.255.255.0 tcp adjust-mss rx mtu tcp adjust-mss tx mtu context cs switch mapping-table calling-pi to calling-e164 MAP_REMOVE_BLANK_CALLERID map restricted to "" mapping-table calling-e164 to calling-e164 MAP_LEADING_ZERO map (.%)-(.%)-(.%)-(.%)-(.%) to 0\1\2\3\4\5 map (.%)-(.%)-(.%)-(.%) to 0\1\2\3\4 map (.%)-(.%)-(.%) to 0\1\2\3 map (.%)-(.%) to 0\1\2 map (.%) to 0\1 mapping-table calling-e164 to calling-name MAP_CID_TO_CNAME map (.%) to \1 complex-function MAPPING_INCOMING_CALLS execute 1 MAP_REMOVE_BLANK_CALLERID execute 2 MAP_LEADING_ZERO routing-table called-e164 RT_ISDN_TO_SIP_0 route T2 dest-interface IF_SIP_0 MAPPING_INCOMING_CALLS routing-table called-e164 RT_ISDN_TO_SIP_1 route T2 dest-interface IF_SIP_1 MAPPING_INCOMING_CALLS routing-table called-e164 RT_ISDN_TO_SIP_2 route T2 dest-interface IF_SIP_2 MAPPING_INCOMING_CALLS routing-table called-e164 RT_ISDN_TO_SIP_3 route T2 dest-interface IF_SIP_3 MAPPING_INCOMING_CALLS interface isdn IF_ISDN_0 route call dest-table RT_ISDN_TO_SIP_0 user-side-ringback-tone call-hold disable caller-name interface isdn IF_ISDN_1 route call dest-table RT_ISDN_TO_SIP_1 user-side-ringback-tone call-hold disable caller-name interface isdn IF_ISDN_2 route call dest-table RT_ISDN_TO_SIP_2 user-side-ringback-tone call-hold disable caller-name interface isdn IF_ISDN_3 route call dest-table RT_ISDN_TO_SIP_3 user-side-ringback-tone call-hold disable caller-name interface sip IF_SIP_0 bind context sip-gateway GW_SIP_0 no early-connect early-disconnect route call dest-interface IF_ISDN_0 remote 192.168.110.50 5060 address-translation outgoing-call request-uri user-part fix 10000 host-part to-header target-param none address-translation incoming-call called-e164 request-uri interface sip IF_SIP_1 bind context sip-gateway GW_SIP_1 no early-connect early-disconnect route call dest-interface IF_ISDN_1 remote 192.168.110.50 5060 address-translation outgoing-call request-uri user-part fix 10001 host-part to-header target-param none address-translation incoming-call called-e164 request-uri interface sip IF_SIP_2 bind context sip-gateway GW_SIP_2 no early-connect early-disconnect route call dest-interface IF_ISDN_2 remote 192.168.110.50 5060 address-translation outgoing-call request-uri user-part fix 10002 host-part to-header target-param none address-translation incoming-call called-e164 request-uri interface sip IF_SIP_3 bind context sip-gateway GW_SIP_3 no early-connect early-disconnect route call dest-interface IF_ISDN_3 remote 192.168.110.50 5060 address-translation outgoing-call request-uri user-part fix 10003 host-part to-header target-param none address-translation incoming-call called-e164 request-uri context cs switch no shutdown authentication-service AS_ALL_LINES realm 1 3CXPhoneSystem username 10000 password xxxxxxx username 10001 password xxxxxxx username 10002 password xxxxxxx username 10003 password xxxxxxx location-service LS_10000 domain 1 192.168.110.50 identity-group default authentication outbound authenticate 1 authentication-service AS_ALL_LINES username 10000 identity 10000 authentication outbound authenticate 1 authentication-service AS_ALL_LINES registration outbound registrar 192.168.110.50 5060 lifetime 300 register auto location-service LS_10001 domain 1 192.168.110.50 identity-group default authentication outbound authenticate 1 authentication-service AS_ALL_LINES username 10001 identity 10001 authentication outbound authenticate 1 authentication-service AS_ALL_LINES registration outbound registrar 192.168.110.50 5060 lifetime 300 register auto location-service LS_10002 domain 1 192.168.110.50 identity-group default authentication outbound authenticate 1 authentication-service AS_ALL_LINES username 10002 identity 10002 authentication outbound authenticate 1 authentication-service AS_ALL_LINES registration outbound registrar 192.168.110.50 5060 lifetime 300 register auto location-service LS_10003 domain 1 192.168.110.50 identity-group default authentication outbound authenticate 1 authentication-service AS_ALL_LINES username 10003 identity 10003 authentication outbound authenticate 1 authentication-service AS_ALL_LINES registration outbound registrar 192.168.110.50 5060 lifetime 300 register auto context sip-gateway GW_SIP_0 interface LAN bind interface IF_IP_LAN context router port 5060 context sip-gateway GW_SIP_0 bind location-service LS_10000 no shutdown context sip-gateway GW_SIP_1 interface LAN bind interface IF_IP_LAN context router port 5062 context sip-gateway GW_SIP_1 bind location-service LS_10001 no shutdown context sip-gateway GW_SIP_2 interface LAN bind interface IF_IP_LAN context router port 5064 context sip-gateway GW_SIP_2 bind location-service LS_10002 no shutdown context sip-gateway GW_SIP_3 interface LAN bind interface IF_IP_LAN context router port 5066 context sip-gateway GW_SIP_3 bind location-service LS_10003 no shutdown port ethernet 0 0 medium auto encapsulation ip bind interface IF_IP_WAN router no shutdown port ethernet 0 1 medium auto encapsulation ip bind interface IF_IP_LAN router no shutdown port bri 0 0 clock auto encapsulation q921 q921 protocol pp uni-side auto encapsulation q931 q931 protocol dss1 uni-side user bchan-number-order ascending encapsulation cc-isdn bind interface IF_ISDN_0 switch port bri 0 0 no shutdown port bri 0 1 clock auto encapsulation q921 q921 protocol pp uni-side auto encapsulation q931 q931 protocol dss1 uni-side user bchan-number-order ascending encapsulation cc-isdn bind interface IF_ISDN_1 switch port bri 0 1 no shutdown port bri 0 2 clock auto encapsulation q921 q921 protocol pp uni-side auto encapsulation q931 q931 protocol dss1 uni-side user bchan-number-order ascending encapsulation cc-isdn bind interface IF_ISDN_2 switch port bri 0 2 no shutdown port bri 0 3 clock auto encapsulation q921 q921 protocol pp uni-side auto encapsulation q931 q931 protocol dss1 uni-side user bchan-number-order ascending encapsulation cc-isdn bind interface IF_ISDN_3 switch port bri 0 3 no shutdown port bri 0 4 clock auto encapsulation q921 q921 protocol pp uni-side auto encapsulation q931 q931 protocol dss1 uni-side net port bri 0 4 shutdown
Hallo!
Du musst über den Debug mal nachsehen, was der ISDN bei einem unterdrückten Anruf bringt. Mit dem kannst du dann deine Mappingtable bzw. Routingtable anpassen.
Es gibt schon einen Eintrag der das ev. schon zu berücksichtigen "versucht":
Wie gesagt im Debug nochmal nachsehen ober der Anruf wirklich als "restricted" reinkommt.mapping-table calling-pi to calling-e164 MAP_REMOVE_BLANK_CALLERID
map restricted to ""
jwm
Provider:
SIP-Provider:
PBX: asterisk
Phone(s): X-lite
Also:
Patton Konfig ist i.O.
Es hat an der 3cx gelegen. Und zwar kommen unterdrückte Nummern mit der 0 rein. In der 3cx war eine virt. NST mit der Rufnummer 0 angelegt. Somit hat das nicht fkt.
TROTZDEM DANKE!!!
Berechtigungen
Zitieren