OK, also ich habe dann mal
reboot factory
durchgeführt. Danach dann über die Efficient DSL Tools -> Quickstart mich mit dem Router
192.168.254.254 verbunden
superuser
admin
Habe dann
Network Options: Bridging
Link Protocol: RFC 1483
und unter Options -> Choose PVC -> 1*51
unter Options -> Change your LAN IP settings -> 192.68.0.117
gesetzt. Das Ganze dann gespeichert und und ihn wieder ans DSL-Netz angeschlossen.
Funktioniert reibungslos,
aber eben nicht der Webserver.
Das ist schon etwas merkwürdig, da die Release-Notes ja sudrücklich von einer solchen Möglichkeit sprechen
Configuration Methods
This product may be configured using several different methods:
- Web User Interface - A Web management interface is available by connecting to the router at the default address of http://192.168.254.254/. An Easy Setup feature is provided to guide you through initial setup of the router.
- Console connection - A local connection via the Console port with a console cable from a PC, enables router configuration from the Command Line Interface (CLI)
- Telnet session - Enables configuration from the Command Line Interface when connected to the default address of telnet://192.168.254.254/
Bei den cli commands finden sich andererseits aber keinerlei Hinweise auf HTTP, wenn man z. B "system list" eingibt finden sich Hinweise zu telnet, snmp u.a aber nicht für http.
Vielleicht ist das Web User Interface im derzeit verfügbaren Kernelfile für den 5851 aus Flashspeichergründen nicht enthalten oder es hat damit etwas zu tun, dass die v6.x laut Release Notes nur für ein bestimmtes Hardwaremodell
This release note applies to the following hardware models:
5851 ATM (PN 120-5851-60x)
gedacht ist und nur zufälligerweise auch für alle anderen Hardwaremodelle geht. Andererseits lautet der Dateiname 5851-634. Alles etwas merkwürdig.