0 channels configured

[iptelefonie]

Hallo,

ich habe ein Problem bein übersetzen des zaphfc-Treibers:

Ich verwende bristuff-0.3.0-PRE-1y-j unter Debian Etch mit Kernel 2.6.18-5-486.
lspci -v:

00:0e.0 Network controller: Cologne Chip Designs GmbH ISDN network controller [HFC-PCI] (rev 02)
Subsystem: Cologne Chip Designs GmbH ISDN Board
Flags: bus master, medium devsel, latency 16, IRQ 10
I/O ports at e800 [disabled]
Memory at fedff400 (32-bit, non-prefetchable)
Capabilities: [40] Power Management version 1

make loadNT
make -C /usr/src/linux-2.6 SUBDIRS=/home/asterisk/bristuff-0.3.0-PRE-1y-j/zaphfc ZAP=-I/home/asterisk/bristuff-0.3.0-PRE-1y-j/zaptel modules
make[1]: Entering directory `/usr/src/linux-headers-2.6.18-5-486'
CC [M] /home/asterisk/bristuff-0.3.0-PRE-1y-j/zaphfc/zaphfc.o
Building modules, stage 2.
MODPOST
WARNING: "zt_transmit" [/home/asterisk/bristuff-0.3.0-PRE-1y-j/zaphfc/zaphfc.ko] undefined!
WARNING: "zt_receive" [/home/asterisk/bristuff-0.3.0-PRE-1y-j/zaphfc/zaphfc.ko] undefined!
WARNING: "zt_register" [/home/asterisk/bristuff-0.3.0-PRE-1y-j/zaphfc/zaphfc.ko] undefined!
WARNING: "zt_unregister" [/home/asterisk/bristuff-0.3.0-PRE-1y-j/zaphfc/zaphfc.ko] undefined!
WARNING: "zt_ec_chunk" [/home/asterisk/bristuff-0.3.0-PRE-1y-j/zaphfc/zaphfc.ko] undefined!
CC /home/asterisk/bristuff-0.3.0-PRE-1y-j/zaphfc/zaphfc.mod.o
LD [M] /home/asterisk/bristuff-0.3.0-PRE-1y-j/zaphfc/zaphfc.ko
make[1]: Leaving directory `/usr/src/linux-headers-2.6.18-5-486'
modprobe zaptel
insmod ./zaphfc.ko modes=1
ztcfg -v

Zaptel Configuration
======================


0 channels configured.

Woran könnte das liegen?

 

[iptelefonie]

Habe es selbst geschafft. Es lag an der /etc/zaptel.conf.