Guest network as tagged vlan on port 2

[frater]

The Fritzbox is capable of creating a secondary network which could be used for a guest-network.
It is capable to put this on port 4 and/or a seperate SSID.

Sometimes I use a WAP with multi-SSID with which I'm able to create these 2 SSID a 100 metres further.
To achieve this I need a managed switch with which I'm injecting the port 4 of the Fritzbox as a VLAN on the cable going to the wireless.

I use a Netgear 108 for this, but it's a bit silly as the switch on the Fritzbox is already using VLANs on that 4-port switch to achieve all this.

Isn't it possible to put the guest network as tagged on one of those ports?
If I need to do this on the CLI than that's not a problem.

I do need to know then how I can get this part into the configuration, so a Freetz configuration restore will get that back too.

 

[frater]

Any information on this is welcome.
Also if there is something missing to achieve this.

 

[meiser79]

About which FritzBox are you talking? BTW, the FritzBox is a residential gateway where VLAN support is normally not available. If you own an older router, you might have success with cpmaccfg which is part of Freetz.

 

[frater]

I'm managing more than 50 fritzboxes, but if I want to do this it would be with one of the modern ones.
I guess no luck there then.
Thanks

Finally I found a cheap managable switch that will also do PoE.
When I need this with PoE I at least don't need 3 devices.